I took a mark similar to where AK had marked the washer jets (c. 10cm inside my bonnet latches) and simply drilled through and then attached the washer jets.
Due to the thickness of the body I did have to reduce the size of the sleeve by about 7mm to ensure I could still get the nut on; easily done with the angle grinder.
The washer bottle wiring is actually located in the dash part of the loom near the steering wheel. This needs feeding through to wherever you have installed the water bottle. You also need to run a 5mm washer tube (I got mine from Halfords) from the washer bottle to the jets, running them through a T-piece. I haven't got to finishing this task as yet but here's a pic half way through job.
No comments:
Post a Comment