I have a few articles that need finishing which hopefully I'll get to at the end of the week but until then heres one little snippet of this weeks work.
- Custom heater system
- Electronic Handbrake
- Side Louvres
- Nose Vents
- Wheel Arches
- Manifolds
Articles to follow on most of the above but I'll cover the Manifold here.
Basically I noticed that there was a lot of soot around the manifolds suggesting a leak. When I removed the manifold to check it I noticed that the hand made, stainless steel manifolds that AK built and fitted had no gasket or even assembly paste on them. No wonder they were leaking!!
Frankly I find this a bit annoying given they cost over £1500, surely its not that difficult to make a gasket too?
So this became an unplanned job for the week. Following a quick clean with some petrol I added a little assembly paste and reattached the exhausts.
The longest job was re-wiring everything so I could start they engine to check for leaks.
Luckily all good.
Luckily all good.
No comments:
Post a Comment