Rear Wiring and Wing Mirrors

The wiring loom is another part done job which I have been trying to complete.

After identifying the legs and loosely running the loom to all areas of the car I have wired in the rear lights & fuel sender.

This involved spending a lot of time in the drivers side rear wheel arch drilling and cable tying the wires into place and then undoing it and doing it again because I forgot to put the battery wire in a protective loom conduit.

I also had to adjust the loom pulling back the handbrake wiring from the normal AK place underneath the drivers door back to the centre console area where I will have my electronic handbrake switch.

I'll post more pictures once I make more progress.

I saw a post this week too for Ken (from the forum) selling some IVA wing mirrors so I snapped them up. I'll likely replace them after IVA but they are ok for now. Easily fitted by bolting into the lowest bolt holes from windscreen.